Nissan Titan Forum - View Single Post - SAW pre-load height?

pipho · 06-26-2009, 10:31 AM

Ive put a call in to grag about this ill hopefully have an answer soon. I put my kit on last night and with 2inchs of thread showing my truck sits over 2 inchs lower then then stock with a 3/4inch thick spacer on top. All my arms and CVs are prefectly strait at 2 inchs as well as the ride was like jello, all mushy. I cranked them up to 2.5inches of thread showing and the ride is better, a little more controlled and not so mushy but im still over 3/4 of an inch from where I started and my CVs are just slightly offset. I would like over an inch more lift with out ruining the ride, and my CV would easily handle it. I dont know whats up with my truck but ill post as soon as I talk to greg.

06-26-2009, 10:31 AM	#6 (permalink)
pipho Registered User iTrader: (1) Join Date: Jun 2009 Location: Tempe Posts: 244 Thanks: 2 Thanked 12 Times in 10 Posts	Re: SAW pre-load height? Ive put a call in to grag about this ill hopefully have an answer soon. I put my kit on last night and with 2inchs of thread showing my truck sits over 2 inchs lower then then stock with a 3/4inch thick spacer on top. All my arms and CVs are prefectly strait at 2 inchs as well as the ride was like jello, all mushy. I cranked them up to 2.5inches of thread showing and the ride is better, a little more controlled and not so mushy but im still over 3/4 of an inch from where I started and my CVs are just slightly offset. I would like over an inch more lift with out ruining the ride, and my CV would easily handle it. I dont know whats up with my truck but ill post as soon as I talk to greg.