TitanZ04

Go to
http://www.nissanusa.com/nismo-web/N...sports-Catalog...

Page 88

is it like a prg or what? just looking for the full name so i can research

Sounds good. not sure which im going with yet.

thanks. I don't think I like the blacked out look at this time. But, I would like to know where or Who did the powder coating?

they are black powder

Great write-up. If pictures were included would make it excellentfor a Tech Manual insert...Thanks.

It was pretty easy. I tried the 4 pin connector first and only the running lights and reverse lights came on. So I decided to hard wire and everything worked. You have to cut off the 4 pin plug that comes with the LED lightbar. Make sure you know what wire goes where. Take a picture of it if you have to, I did. The first wire on the left is your GROUND WIRE. Connect that to any part of the body that is metal and NOT PLASTIC. I just did mine to the bumper where the other wires are running by. Your 2nd wire is your brake lights. Just tap into your brake light wire from either your left tail light or right. You can use a splice tap or T connector. Removing the tail light would help with this installation if you don't know what wire is what. The remaining 3 wires will connect to the wires that are marked MAJOR. Just look on the tail light plug and it will tell you MAJOR, MINOR, and GROUND. Again tap into the one that says MAJOR. Your third wire is left turn signal and the 4th wire is your right turn signal. I ran mine from the middle so I had 3 wires going to the left tail light and the 4th wire going to the right tail light. Test all your lights to see that they work before you manage the cables with zip ties or what ever you want to use. You can use HEAT SHRINK to cover your connections and a silicone sealant to make it water tight. As for bar positioning removing the tailgate helps with placement and alignment. I used automotive grade velcro to secure my BAR and am very pleased. Better then the bars tape. Make sure to clean with alcohol first. This is for the PLASMAGLO 60" LED FLEXIBLE Light bar. I don't know how the other LED bars connect but I'm guessing that it would be the same. Good Luck!!!

If you don't mind can you find a pic of what they look like, I've found a few styles of the 6 spoke ones and hate to make you open a box if they're ready to go. I was set on the 5 spokes but I have seen a few of the 6 spokes I like. Thanks.

The hoods are pricey, but I believe there is a special going on right now. Check the website...I live in SC and shipping is 100.00. Shipping to AK might be a bit more....

Still Active duty, currently in Alaska. No group buy as of yet because the guy is currently not a sponsor. The prices are still the same. Honesty noone has really showed any interest except you. I doubt there would of been enough folks for a group buy. Papa D AND Dbolemiss have the hoods with extractors andlove them.