I just used one piece that fit over the upper bezel, placed it on there and then used a steady hand and utility knife with a brand new blade to cut around it. Actually the piece that covered the upper bezel and the radio bezel was all one piece. It was easier when the vinyl wasn't hot or warm, I did it in the morning when it was still cool out, seemed to cut better/easier with no bending. Used my thumbnail to mark the area to be cut, traced the slot between the bezel and dash so you could see the outline. Cut closer to the dash side and then again use the thumbnail to push the cut into the crack between the bezel and dash. I have the Hatchie Bottom Armour Suedes on my truck, least expensive custom fit I could find that still had an actual camo (Realtree, Mossy Oak, Etc) pattern on them, they run about $170 a set for the front and same for the back.