Hawaiianbasshead

hey, don't come on here often. they do rub, but they mostly rub the frame I think. I did the pinch weld mod. and my rims have a really positive offset 5.79" iirc so they tuck in close to stock. I don't get any rub on spindle or UCA... I hear the mud grapplers are wider tho and stock rims are MORE tucked in so you may have issues I don't know.. start a thread. plenty of guys ran mud grapplers on stocks before with just leveling kits I believe so you "should" be fine as far as I know...

Me and you have about the same setup. I just put 08 Pro4x coilovers on and got another 1.5" of lift. So I am around 6.5 in the front with everything. How do your 35's fit? I am taking the XD's off the titan and putting the stock LE's on with some new 35X12.50R18 Mud Grapplers and I am worried that they are gonna rub like a sum *****. I figured I would see how your set up works. I am more concerned with contact with the spindle and upper control arm.

um, 4wds are a little higher stock. and from what I've compared my truck to other 4wds mine was kinda higher stock since I have the OR package... so I'm not sure how far over stock it is. I have a 2.5" spacer and bodylift so 5.5" over stock up front. the one ur talkin bout must be chieflikalotapus? the fiji blue one with the 33s on 20"s? his is around the same height as mine. I think u should start with the spindles then add a 2.5" leveling spacer. or even get the spacer 1st since it's the cheapest and go from there. the best way to see if u want more is to add it little by little imo. I want more but also don't wanna run 33"s so I can get some power back. so it's a toss up really for me. I think I'll keep the height I got and get the 33x14 or 15.5"s eventually for now I'm gonna get some smaller 35"s, so I don't have to get different rims. its a money pit at best lol.

Since you have a 4x4 and a 3" BL,I have to ask you this. I plan to lift my T a little with the 4"Spindle Lift with the PRG 1.5" spacer in the front. That will out me at 5.5" of lift in the front. In the back I plan to replace the rear shocks with SAWs and a 2" block. I saw a 4x4 on here with a mini lift(2.5" spacer) and a 3" BL. Does this equal the height of my 2wd or slightly higher by an inch or so? That looked to be the perfect height that I wanted but can't seem to find the equivalent height for my 2WD. I plan to run 20x10's with 33.12.5 toyo M/Ts.

local 4wd shop would go with a 20x10 or 12" if I did it again I guess... my last set of rims had a negative offset and stuck out more so I may get another set of wheels that stick out for my mud tires

Hey man, where did you get your rims?

you from hawaii?