Im not sure on the offset, but I had 33" toyo m/ts on mine befor with these rims, and with the 4 inch spindle plus the 2.5 spacer it was perfect! No rubbing. When I went up to 35's I had to cut the fender on the bottom and some of the pinchweld. So You should be ok! And no still havnt sold it

depends, I have to wait till MID SEPT till I get some funds before I can do anything. I plan on getting the 4" Spindle lift. People keep telling me that 6" is too high to run 33s x 20's. I dont want to go bigger than that because of gas prices and the Toyo's are pretty heavy as is. So I''m think 4"-5" Spindle and spacer. As for the wheels been looking for the 20x10 Diamo's or Eagle One Alloys 064b. I just need to know the right offset and BS to prevent any rubbing on the spindle and Pinch-Weld. Figure ask you since you have a similar setup. Have you sold everything?

Do you want to buy my lift or wheels?

hey I plan to get those rims. What is the offset and backspacing you running? any rubbing and pinch-weld mods? I will be running a 6'5" PRG lift. what did that cost you and from where?