Loufish -

It sounds like you are running a similar set-up to mine and wanted to ask you a question - Will I need airbags?

I picked up my lift kit from PRG and installed it over the weekend:

- RadFlow coil-overs (new PRG/RF shock & hat design) w/ 600lb springs
- Upper Control Arms
- Deaver Mini-pack (1.5")
- Shackles (using lowest setting)
- SAW remote res. rear shocks

I am heading out to Ocotillo this weekend and will have 3 bikes in the bed (~700lbs) and will be pulling a 25' travel trailer (not a toy-hauler) with a weight-distribution hitch. I typically don't carry this much weight in the bed, I usually only carry 2 bikes (~500lbs) in the bed.

My question is this - Do I need airbags for this set-up, or will I be okay without them? How much sag should I expect if I didn't use the airbags - I would expect that I would be at about 1,000lbs between the bikes and tongue load.

Thanks in advance!
- Chip
chipreibel@yahoo.com
(310) 974-2719