2006 titan intake manifold

jonmeskeete · 10-11-2011, 06:17 PM

I had to replace the starter on my 2006 Titan and as we all know it is conveniently located under the intake manifold. I have removed everything and i am going to be putting the starter in but I do not know what i should torque the bolts down for the intake and if there is a specific pattern when I do. if anyone knows and was willing to share it with me I would be very great-full.

**DanBlp** · 10-11-2011, 08:38 PM

Attached is the pattern at 73 in-lbs.

jonmeskeete · 10-12-2011, 05:50 AM

Quote:

Originally Posted by DanBlp

Attached is the pattern at 73 in-lbs.

thank you for the patern. if i did my math correct the torque is only 6 ft lbs??? My torque rench only goes down to 20 ft lbs and I went online to find one that goes that low and have not been able to find one did i do my math wrong or is this suposed to 73 ft lbs

**DanBlp** · 10-12-2011, 07:45 AM

Quote:

Originally Posted by jonmeskeete

thank you for the patern. if i did my math correct the torque is only 6 ft lbs??? My torque rench only goes down to 20 ft lbs and I went online to find one that goes that low and have not been able to find one did i do my math wrong or is this suposed to 73 ft lbs

6 ft-lbs is correct. If you have a harbor freight near, you coul pick up an in-lb wrench pretty cheap.