Installing billet grill. How to?

[RememberThisTitan]

got my grill today and started looking under the hod and dry fitting it. how did you guys install yours. mine is mounted with bolts over the existing grill. i cant see how you are to squeeze your hand behind the factory grill and thread these new bolts. just aint any room. the only way i can see this being easy would be to remove the factory gill, install the billet, and then reinstall everything. anybody else have this kind of set up?

[CaliforniaTitan]

That is by far the easiest way to do it....look around the outside edge....you will see the 1/4 turn clips with a flathead opening. 7 of them around the outside.

1/4 turn on each and out comes the grille. To re-install - take the clips and plug them back into the grille then just push the grille into place.

Chris

[gr8titan]

Originally Posted by CaliforniaTitan

That is by far the easiest way to do it....look around the outside edge....you will see the 1/4 turn clips with a flathead opening. 7 of them around the outside.

1/4 turn on each and out comes the grille. To re-install - take the clips and plug them back into the grille then just push the grille into place.

Chris

There are four (4) plastic hold downs a quarter turn release accross the top, three (3) on the bottom and two (2) on either side for a total of eleven (11) quarter turn hold downs. Visit my site www.usantonio.com/busrtsphoto2A.htm as I posted the enclosed steps when I intalled my billet inserts. If you can not enlarge the picture to be legible, leave me a fax # and i'll fax it to you. Good luck

[RememberThisTitan]

thanks for the help guys