Need Radio Help!!!

Nissanloyalist · 10-24-2004, 10:31 AM

Just installed a Peripheral SVEN4 loc to RF HU. This is a two amp systm with an Alpine V12 4ch and a V-Power 2ch for the subs. I installed 2 pairs of Alpine X components and ran new wire through the door boots.My question is I wired the loc with the sosche harness including the reverse harness as specified on the package as well as color and wire cordination on the loc. there were a couple unused wires. Has anybody had this? Also now the HU will not turn on. There is power to the face plate. The hazard light switch as well as the airbag indicator works. The clock is running, but NO buttons on the stereo or the steering wheel control are functioning. The loc is ground and the power antenna is plugged back in to the HU. Any help would be most appreciated.

Nissanloyalist · 10-24-2004, 08:47 PM

Took HU out and found that the plugs came out. EVERYTHING WORKS GREAT!!! Sounds wonderful.

bestatchess · 10-24-2004, 08:54 PM

Cool !!! What did you do with the Dimmer Ground (orange w/black stripe)?

I am wiring a couple of amps to RF HU at the moment, also using LOC and Scosche harness/connectors. I am running Amplifier Ground, Chassis Ground, and Pre-Amp Ground (Audio Control Matrix) from the front of the cab to a distribution block at the rear of the cab where my power amps are grounded. I have a relay for the remote turn ons for the pre-amp and two power amps.

smoketitan · 10-25-2004, 12:07 AM

what scosche connectors did you two use by the way??

bestatchess · 10-25-2004, 03:18 AM

Quote:

Originally Posted by Nissanloyalist

Took HU out and found that the plugs came out. EVERYTHING WORKS GREAT!!! Sounds wonderful.

Did you use NN03 & NN03RB and the RB connectors don't quite click to the detent in the HU ???

Nissanloyalist · 10-26-2004, 12:29 PM

I used both the sosche (NN03 & NN03R) connectors and everything is working great. The dimmer wire I did not use and just taped that up. I ran 4ga wire from batt to a distribution block where I ran 8 ga wire to the amps. I used the remote turn on wire from the loc and spliced it into two for both amps. I also used the sosche 6X9 adapters for the front and they fit perfectly to the stock mold. Everything just pluged in nicely. I was able to fit the loc just behind the 4x4 switch and it fits snuggly with no rattles and I didn't have to drill any thing. My friend is in the process of builing me an amp rack for behind the seats. I want to thank everyone who posted info on this subject because without this site I don't think I would have been able to do this on my own. THANK YOU!!!!!!!!