Anybody have the Nissan chrome tailgate accent?

[baseballfanz]

Originally Posted by daptech

I think the HUGE black bib looks like crap on a white Titan.........IMO

Using both together look good IMO.

[Blackbeauty]

I like that too. Gives the bib "contours" rather than just being flat... Very nice.

[Anton3655]

Originally Posted by daptech

I think the HUGE black bib looks like crap on a white Titan.........IMO

^ Very creative - I had the u-shaped one, but never thought about doing a duel trim set. The combination of both looks much better than any single trim piece - nice work

[StrayCat]

If you have harsh winter weather stay away from the plastic chromed partial plate. It just won't hold up. Installed one in October it was trashed by January. It pits, bubbles, and peels away. I complained to the vendor which notified the manufacturer and they sent me a new one free of charge. But what's the point.

I'm about to install the stainless full piece bezel which will stand up to VT winters just fine.

Question. Any ideas on how to remove the old plate. It's held with 3M Tape that's damn near as strong as super glue. Any suggestions would be great. Thanks.

[HSUReddiePB]

air chisel...

[daptech]

Originally Posted by StrayCat

.......................
Question. Any ideas on how to remove the hold plate. It's held with 3M Tape that's damn near as strong as super glue. Any suggestions would be great. Thanks.

I removed the chromed U-shaped trim after it had
been on for two years...........heat gun & slid plastic
bondo spreader under it.

[StrayCat]

Originally Posted by daptech

I removed the chromed U-shaped trim after it had
been on for two years...........heat gun & slid plastic
bondo spreader under it.

What's a bondo spreader? Is that similar to a putty knife or small joint compound trowel?

[daptech]

Originally Posted by StrayCat

What's a bondo spreader? Is that similar to a putty knife or small joint compound trowel?

It is a flat piece of plastic, relatively soft & less likely to
scratch than most other objects.
I get them in auto section at Walmart.

[baseballfanz]

Originally Posted by StrayCat

Question. Any ideas on how to remove the old plate. It's held with 3M Tape that's damn near as strong as super glue. Any suggestions would be great. Thanks.

If you don't care about it breaking, just rip it off. If you want to save it, heat it up a little, even a hair dryer will work, than use fishing line to remove it.

[StrayCat]

Thanks guys. That was helpful.

[flipcrab85]

Originally Posted by JBrawn

Here's one from another angel and a better camera.

unless if that was taken with a cell phone, you should consider buying a new camera...that is the nosiest pic ive ever seen