need help installing oem fog lights and kc lights on bull bar......

slice07 · 05-12-2008, 07:33 PM

ok i have a 07 se titan didn't come with fog lights so i bought some oem fog lights. i was going to attempt to install them today and put em in the bumper and can't figure out how they secure in place?.... what holds em in place? it says nothing about that in the instructions...... how does ur fog lights secure?

and second... i bought some kc daylighters to go on my bullbar..... well the bolt is only 1 1/2 - 2'' long. not near long enough to go all the way through the predrilled holes on the bullbar. i thought if the bolt was long enough it would go all the way through the tubn and fasten that way....... i could really use sum help with this....... thanks allot in advance.........

**Carbeaux** · 05-12-2008, 07:38 PM

Hmmm, first I don't know about the fogs.

But on the Daylighters for your bull bar, the bolts only need to be long enough to go through one wall of the tube. My Westin is a 3" bull bar but has holes on the top of the crossbar that are large enough for the bolt to go through. There are larger holes on the bottom to put the nut through to the bolt to tighten it down.

slice07 · 05-12-2008, 08:17 PM

yes it has a larger hole on btm for the nut. i figured that was the only way..... that's goin to b a *****. lol it came with two washers with the rubber on one side. but ok if that's the only way i g uess that'll do.

ablexus · 05-12-2008, 08:31 PM

You punch out the old black plastic pieces from the fog light holes, and push the new fog light into its housing, with the metal screw posts going all the way into the rear. There should be 8mm nuts that hold the thing in. Snap in the new harness and off you go.

Andrew

dc_909 · 05-13-2008, 08:10 PM

The fog lights are marked which is left and right, just remember, when facing the front of your truck, left is now right

I had a thread not long ago about Fog Light kits and 2008+ Titans, lemme dig it up, I linked the Directions for install on them also .......

ok here ya go

http://www.courtesyparts.com/Merchan...de=999F1-A6001

slice07 · 05-13-2008, 08:31 PM

oookkkk thanks that linked helped allot..... i didn't get the two "grommets" is what they called em. the plastic pieces that actually snapped the fog light in place. and i didnt' get a screw....... wonder if the dealership would have them in stock......have to go by there neway cuz i gotta get some fuses that go to the trailor wireing. my titan didn't even come with the fuses!!!!

**Kronos1965** · 05-13-2008, 08:59 PM

Quote:

Originally Posted by slice07

yes it has a larger hole on btm for the nut. i figured that was the only way..... that's goin to b a *****. lol it came with two washers with the rubber on one side. but ok if that's the only way i g uess that'll do.

Yes it was an a***** to install mine!

IF I did it again, I would use longer bolts and then get a big washer for the bottom hole and secure the whole thing from the bottom as opposed to the inside of the westin top bar...