Which one Fabtech or Procomp?

[atvdevil250]

I cant decide which one i want think you guys could help me out?? Any one eadier to install than the other?? thanks for the help

[Smokey]

Pro Comp is straight bolt on, Fab Tech has some grinding/cutting involved up front. Not exactly sure of what since I went the Pro Comp route. Both have blocks in the back. Either one you should think about getting the 2 1/2" leaf pack and eliminate the block. PRGproducts.com has everything you need. So I think the Pro Comp would be the eisier of the 2.

[i<3mytitan]

another thing you want to think of is exactly how high you want to go. With the FabTech, Greg has a custom-spacer that goes on top of the coilovers (i believe it's only for the radflo's), so you can get an additional 2" on top of the 3" the coilovers give.

[Smokey]

^^That's another good point. How big you want to go will lead you in 2 different paths. As i<3 said, FabTech can be set up taller. But if 6" is enough, I would think about the ProComp. Just my 2 cents.

[atvdevil250]

how much more are the addaleaf kits?

[Smokey]

They are considered mini leaf packs. They have 3 leafs total and replace the factory overload. Cost: just over $200. http://www.prgproducts.com/titan_rear.php

[atvdevil250]

would this be the same thing just an alternative instead of using blocks??

[i<3mytitan]

pretty much.

[supadupaj]

Originally Posted by i<3mytitan

another thing you want to think of is exactly how high you want to go. With the FabTech, Greg has a custom-spacer that goes on top of the coilovers (i believe it's only for the radflo's), so you can get an additional 2" on top of the 3" the coilovers give.

That is my exact set up and with the 37's on I am sitting about 12" over stock and I have another inch I could crank up the radflos... No rubbing at all with the 37's...