Something bad to say about knukonceptz

grunge311 · 06-20-2005, 08:55 AM

I finally have my stereo done in my truck, I used all knukonceptz wire and I have on complaint about there product.

The ends RCAs break in half very easy. As I was test fitting the amp behind the seat I would put the seat up and down to check for clearence. while doing this 3 of my 4 RCA ends snapped off IN THE AMP!! The male part of the connecter (+) breaks off of the female part (-). I had to disassemble my amp and push the pins out from the inside.

Other than that there products work great.

baseballfanz · 06-20-2005, 09:10 AM

Quote:

Originally Posted by grunge311

Other than that there products work great.

titanse05 · 06-20-2005, 10:24 AM

Sorry about your luck....I just installed a 2ch and 4ch set with no problems. I hope that you sent them back and they gave you new ones.

grunge311 · 06-20-2005, 10:31 AM

I haven't contacted them. If anyone is to blame it was me, had I known there cables had a weak spot there it could have been avoided. I just ran and grabbed some monster cables for $40 to replace them.

I would buy there products again, and just treat them gentler than I would with other cables.

All the other stuff (distro blocks, battery terminals, wires) I ordered from them was top notch. I just thought I would post this so hopefully someone else learns from my mistake.

Sammy Sandbag · 06-20-2005, 12:35 PM

I bought all my wiring through KnuKonceptz and was very pleased with not only their quality but also their pricing. I do have a similar complaint though. The RCA's I bought aren't very sturdy, at least not for my rough handling. They are top quality, but be careful not to pull at the wire. I had a tough time getting a hand on the actual connector, but that should be the only method of disconnecting a interconnect. I pulled two wires from the end plugs. One I was able to reinsert, the other I had to solder the wire back. Other than that, their stuff is top notch and their customer service is great.

smoketitan · 06-20-2005, 01:11 PM

thats odd?? what rcas are you using? for them to break off liek that

im using the kystal cables and it has worked great

did you get your money back?

Justintoxicated · 06-20-2005, 06:50 PM

I got the Silver and Blue RCA's and what I noticed is that when you plug them in they plug in real tight, like you can't really rotate them or anything. I have not had any problems with them and have removed them several times but I always pulled on the ends of the plug not on the cable so far. I htink it's a good thing they are tight ensuring a real nice seal and connection, on the other hand I'll be it adds to the problem of yanking on the cable part and having the ends come off.