Pac SWI-JACK Question

holder · 05-18-2008, 01:55 PM

I just replaced the head unit in my 2008.5 Titan LE/Rockford system with the Kenwood DNX8120 and I am trying to add the SWI JACK to retain the steering wheel controls---PAC's site says "the Plug is located in the AV Switch panel control module. This control module can be found by following the AV Switch panel harness into the dash. I CANNOT FIND IT. Does anyone know where this is and how to describe the location to someone who is not an expert at this stuff!!

Thanks,

Spooner · 05-26-2008, 08:12 PM

I just installed my Kenwood 6019 in my '04 with RF and there were two plugs that went to the factory deck that werent used... I assumed one of those were for the steering wheel controls.

How much did you pay for the PAC unit? I used one in my old VW and it was super easy to install.

FourDoor · 05-30-2008, 02:42 PM

This was the plug I tapped into for my PAC SWI-PS:

A little more detail here:
Succesful audio install on 2008 Titan

broncho4 · 07-27-2008, 10:01 AM

Did you have any luck getting the SWI-JACK to work? I have the same head unit and my local shop cant get the steering wheel controls to work.

Any advice would be great!

I have an 08 Titan CrewCab LE with:
Kenwood DNX8120 - with iPod, Sirius and SWI-JACK controls
Alpine MRP-550 4 channel amp
Alpine MRP-850 mono amp
2 sets Alpine SPR-17S Component Speakers
2 Rockford Fosgate P3SD210 sub woofers
Visiontech VTL420 Back-up Camera
Alpine PKG-M780 Headrest Monitors

**tech12volt** · 07-27-2008, 10:42 AM

I just did an 8120 with the same SWC on Monday. It was not in an 08 . It was an 06 but it worked perfectly. So its not the headunit or swc thats the problem. The wires could be different on an 08. I will call my buddy at peripheral tomorrow and see what he can find out for me.

broncho4 · 07-29-2008, 02:54 PM

Any luck on the wiring question to your buddy?