Vdc, slip, and brake light on

MartyJones · May 25, 2015

I have a 2005 Titan that just started getting the vdc, slip, and brake lights on. The previous owner had the master brake cylinder replaced about 6 months ago. Any ideas on what could be causing the problem? I have read that it could be the ABS sensors. The lights come on randomly and turn off after I cut the truck off.

Any suggestions on what to check?

Walrus · May 25, 2015

Brake fluid level first.

MartyJones · May 25, 2015

I checked brake fluid and it is where it is supposed to be.

jmredmond1233 · May 25, 2015

I had this same problem if you speedometer isn't working as well with other problems check fuse 21 under hood for abs ecm to see if it's blown this was the case in my situation

butterbean · May 26, 2015

There are a several issues that could cause this. Assuming that you have checked the above issues here are a couple more. If it intermittent check the connections at the ABS sensors where they join up to the wiring harness or check the wires from the harness to the sensors. Is your exhaust pipe intact? A lot of times these will rust and come unconnected right after the muffler and the heat can melt the wiring harness there causing massive issues. If all of those lights are on it should be in the rear of the truck so check the things I listed. That's all I've got as far as suggestions. Other than the obvious bad sensor.

El Mamito USMC · May 26, 2015

it sounds like an abs sensor. I had that same issue.. replace it and back to new..

Lee-the-Impaler · May 26, 2015

Check
Your
Parking
Brakes.

MartyJones · May 27, 2015

I double checked the fluid and it was just a pinch low. I added a little fluid and so far no lights. We shall see. Seems very finicky though on the fluid level.

Vdc, slip, and brake light on

Top Contributors this Month

Recommended Communities