Nissan Titan Forum banner
1 - 2 of 2 Posts

· Registered
3 Posts
Discussion Starter · #1 ·
Recently had the front drive shaft from the transfer case come loose and in the process ripped the wires out of the left rear 02 sensor. The plug was also ripped off and is gone. Have repaired the drive shaft and am in the process of replacing the 02 sensor. The one I have ordered is a jobber model (Walker 25024453) and I am not sure if the wire colours will be the same. Does someone have a wiring diagram that would guide me in installing the new sensor and a new plug connector. Thanks
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.