Nissan Titan Forum banner
1 - 20 of 24 Posts

· Registered
Joined
·
17 Posts
Discussion Starter · #1 ·
Have a 2005 titan. Idles and starts fine. If you try to drive it it will only do 30 mph or so and runs really bad. If you rev in neutral it wil rev to 2500-3000 and misses and shakes when it starts missing one bank goes lean .60 v. And the other goes to 2.2. At idle both banks are 1.5. Fuel pressure is 58psi Any help would be appreciated. Cats have been gutted also. The rest is totally stock

Thanks kerry
 

· Registered
Joined
·
1,629 Posts
You're in limp mode. It's a computer issue. This is diagnosed on the board here, well known, but off the top of my head can't remember the issue name. Start by looking at any posts with IPDM relay.
 

· Registered
Joined
·
17 Posts
Discussion Starter · #3 ·
I have swapped the relays and still no luck. Anyway to know that you are in limp
Mode? I have a snap on modis scanner. It shows only p0300 random. Misfire it has a leaking exhaust manifold gasket and a busted trans mount. But can't see them causing this. Any help is greatly appreciated. Willing to pay
 

· Registered
Joined
·
360 Posts
check the parameters of o2 sensors, then go from there, check the air fuel ratio compare bank1 with bank2 , i'm guessing you have bad o2 sensor
 

· Registered
Joined
·
17 Posts
Discussion Starter · #12 ·
Wow no one ???? Ok. I started today if I go 3/4 throttle is revs to about 2300 sat there for 15 seconds or so and then climbed to 3000 rpms and sat there a lil and came back down. Doesn't act like a limp mode and smells extremely rich. Fuel smell everywhere
 

· Vendor
Joined
·
8,028 Posts
If you gutted the cats are you sure the manifolds aren't cracked? That is usually what causes the cats to fail on this truck. You need Uprev tuning as well to correct the fuel mixture with gutted cats. Possible engine damage can occur on non flex trucks due to lean conditions. You cant uprev tune a cracked manifold either so I would prepare for JBA longtubes.
 
1 - 20 of 24 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top