Use a piece of 2x6 between your jack and the oil pan. Remember to only loosen one side at a time. You want to tilt the engine, not lift it straight up.
2007 4x4 header install issue
Good evening folks. Please don't flame me for this as this is my first post. I recently bought an 07 LE CC 4x4 and both manifolds are cracked. I bought some headers and set out to knock it out today. I managed to get the passenger side swapped out by taking the studs out because I can't get the 4 bolts for the MM out. What's the trick? I lifted up on the motor at various pressures and tried to break them with an impact with no joy. I also couldn't get to the two front ones on each side because how the heck! I thought they were only torqued to 65ft/lb. I have searched and searched but every post I found, the photobucket link for pictures was broken. So please..... can anyone give me the guidance I need? Thank you all!
1 - 3 of 11 Posts
This may seem like a dumb question, but did you try using hand tools?
That sucks you have to do that. I had my front diff out when I did mine, and the MM bolts going into the block were no trouble at all. Best of luck to ya!
1 - 3 of 11 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Nissan Titan Forum
Nissan Titan Talk Forum is a community for truck owners to discuss the Titan Cummins, Warrior, Midnight Edition and more!
Full Forum Listing
