[Titandriver'16]

Hey all, I put on a 6" RC lift with Bilstein shocks in the front on stock perch, and RC shocks in rear... I have 33s right now and was wondering if I could fit 37s with the pwm and the same 20x9.5" rims I have now

Sent from my XT1650 using Tapatalk

 

[ttucliffhanger]

You should be able too. I only have a 1 1/2" level and I have 295/70r18 which is like a 34.5" and I barely rubbed at full torque.

Sent from my SM-G930V using Tapatalk

 

[MTKross]

Hey all, I put on a 6" RC lift with Bilstein shocks in the front on stock perch, and RC shocks in rear... I have 33s right now and was wondering if I could fit 37s with the pwm and the same 20x9.5" rims I have now

Sent from my XT1650 using Tapatalk

It depends on your rims back spacing. I have 36's on mine with -44 offset and I had to do ALOT of trimming for them not to rub. 37s would be even worse.




Sent from my iPhone using Tapatalk

 

[Titandriver'16]

If BSM means backspacing then mine is roughly 6.250... Is that good or bad haha

Sent from my XT1650 using Tapatalk

 

[LaxDfns15]

It's better for trying to fit a bigger tire, but you might start rubbing things like the spindle if they're wide.

 

[Titandriver'16]

It's better for trying to fit a bigger tire, but you might start rubbing things like the spindle if they're wide.

Would 12.5 wide rub?

Sent from my XT1650 using Tapatalk

 

[LaxDfns15]

Uh it probably won't hit the spindle/UCA or anything, but you'll probably have to trim the fender. May hit frame too.

 

[Titandriver'16]

Im just gonna get a rim and tire package with 35s and be done with it... Be better overall

Sent from my XT1650 using Tapatalk