Ordered the Maxtrac 4inch Spindle lift for my '11 2wd. I want to run 305/55/20 AT's with 20x9 either -12 or +1 offset wheels. Does anyone have this setup? I'm just doing the 4inch lift so no spacers, coils, or Bilsteins with it, I'm just trying to get an idea of if they will work without rubbing the spindles itself.
If it rubs in the wheel well I can just trim that if they don't fit. I've tried looking through other forums to find it but I've noticed a lot of people going to the 6.5in lift with these spindles and spacer. Also I will have the Rough Country UCA's on too from where I previously had the 3inch Rough Country leveling kit.
If it rubs in the wheel well I can just trim that if they don't fit. I've tried looking through other forums to find it but I've noticed a lot of people going to the 6.5in lift with these spindles and spacer. Also I will have the Rough Country UCA's on too from where I previously had the 3inch Rough Country leveling kit.
