[Dave Da Kyd]

i want to level the truck out, is it possible with these.
i really want to a better right aswel.
do i need cambolts to get it aligned? if so i already have them.

how much do you think 4x4parts would install to put them in?

 

[bhamby3]

i want to level the truck out, is it possible with these.
i really want to a better right aswel.
do i need cambolts to get it aligned? if so i already have them.

how much do you think 4x4parts would install to put them in?

Yes if you get a the adjustable 5100's you should be able to level out the front end and also get a little better ride than stock. You'd get a much better ride with some after market coil overs. I would estimate 4x4 parts would want close to 300+alignment probably to put them on. By the time you did that, you're looking at around 500-600. You could almost buy some after-market's for that price and put them on yourself since you wouldn't need a spring compressor.

 

[Book0825]

i want to level the truck out, is it possible with these.
i really want to a better right aswel.
do i need cambolts to get it aligned? if so i already have them.

how much do you think 4x4parts would install to put them in?

I have an 09' with 5100's set at the middle notch. Front sits .05" lower then the rear. I did not need to get camber bolts the tech that aligned my truck afterwards showed me the tech sheet and the only thing that changed was the toe. I also did the install myself so it only cost me 60 bucks to get it alligned at sears.