$95 for two runs on a dyno?

75.00 for three pulls around here, that sounds a bit steep.

anmut said:

Does that sound right? I found a place within driving distance of me and that's their standard charge. I didn't think it would be that expensive to back up a truck on a roller and hook up some chains.

Click to expand...

Hope that includes some lube....:rofl:

I usually hit up the dyno on a group buy. 40-70 bucks(depends on shop) for three pulls.

Yeah, that's alot for two pulls. Tell 'em you'll pay that for three pulls.

I agree, way to high unless they will be tuning for you... if not as suggested ask for 3/75 bucks

Thanks all for the input!

really thjat how much they run? damn thought it would be alot higher than that. damn might have to check around. I live by chillicothe oh about 45 min south of columbus any places guys?

It also depends on their dyno setup. If they have an in-ground dyno then it doesn't take as long to setup. We have an above ground dyno and it's outside so we have to drag our dyno computer out to it, and hook everything up. It takes about an hour just to get the truck setup on the dyno, then about 30 minutes or so to do 3 pulls (allowing for adequate cool down time between each run) and then another hour or so to take everything apart. We charge $125.00 for three pulls. On our dyno days though we only charge $50.00 for 3 pulls.

From the photos it's an inside dyno. They make engines at this place so I bet they use it all the time. I'd almost bet that the price is to keep the riff-raff ricer boys out.