Nissan Titan Forum banner
1 - 10 of 10 Posts

· Registered
Joined
·
172 Posts
Discussion Starter · #1 ·
After reading a post about upgrading the halogen fog lights to LED, I did just that. Before I go out in the 15 degree cold to look how to change out the bulbs, can anyone offer a quick tip or two about what I'm going to need to do. Seems like it might be a simple job, but with it being the dead of winter and a two week long cold snap, I'm not feeling too motivated to go peeking underneath.
 

· Registered
Joined
·
8,304 Posts
fogs are easy, access them through the wheel well. Headlights are a little tougher, but just need to remove 2 screws in the fender liner and peel it back
 

· Registered
Joined
·
1,554 Posts
are you asking for a gen 1 or gen 2. gen 1 titans its very easy to get at, gen 2 not so much
 

· Registered
Joined
·
65 Posts
After reading a post about upgrading the halogen fog lights to LED, I did just that. Before I go out in the 15 degree cold to look how to change out the bulbs, can anyone offer a quick tip or two about what I'm going to need to do. Seems like it might be a simple job, but with it being the dead of winter and a two week long cold snap, I'm not feeling too motivated to go peeking underneath.
Dude...Just go look.

It's complete open on the gen 2. Lay on you back. grab the fog. turn to release and insert new bulb.
 

· Registered
Joined
·
359 Posts
Gen 2 was super easy. Literally took 3 minutes to swap out both sides.
 

· Registered
Joined
·
1,554 Posts
Gen 2 was super easy. Literally took 3 minutes to swap out both sides.
i only looked quickly didnt actually go under. from the side it looked enclosed.
i have to swap the housing for my morimoto LED one

have you swapped out your high beam bulb yet?
 

· Registered
Joined
·
359 Posts
Housing would be more involved. Still not too terrible though I wouldn't think. Mine were just the bulbs.

To be honest, biggest thing keeping me from swapping out the hi beams is that I heard that they are a pain to get to. Haven't verified that myself yet.
 

· Registered
Joined
·
1,554 Posts
i just looked briefly at them couldnt even really tell on the back where they were on gen 2. probably gotta go through the fender
 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top