Nissan Titan Forum banner
1 - 3 of 3 Posts

· Registered
34 Posts
Discussion Starter · #1 ·
I am going to install a cold air intake, and I am looking for a scoop solution, that uses the least amount of ducting possible. Ideally right over the intake. Has anybody done this, or one off the drive side front fender? Even if it's just a louvered grill with a flange to go through to the air intake replacement compartment, I think it would work.

1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.