[adampro4x]

Hey guys.
I just recently purchased a 2012 pro4x. My question is, if I get the RC 3 inch level/lift kit, will that be ALL I need to bring the front end up with the rear? Will there be any CB contact with that kit as is? Or do I need to mention when ordering that I have a pro4x to maybe get a smaller spacer? I've been reading through all these posts and there is so much good information! Almost TOO much info, so it gets confusing! Which is why I figured I'd just go ahead and check with you nice fellas before pulling the trigger. Thanks in advance!

 

[JLG7820]

You can get a solid billet 1.5 inch spacer on eBay for 60 bucks and that will level you out. Any higher then you have to change UCAs. They rc kit is really about 2.5 inches but comes with UCAs and sway bar links. It will work fine too. You will have more of a lift in the front than the rear with out rear blocks.its all about preference. I have the rc 3 inch kit on my 06 with 08+ springs and no blocks in the rear. It's about an inch higher in the front but since I rarely load the truck down anymore I like the look.

 

[adampro4x]

Thanks for the info. Your truck looks very nice! I don't really like the low front end rake at all on trucks. I know it's purposeful when towing or loading in the bed so it doesn't sag, but since I don't have anything to tow or load other than a 450 quad occasionally, I may just leave the rear end as it is like you have done.