Any info on KMC Wheels??

905 Views 6 Replies 3 Participants Last post by dank78, Aug 14, 2007

dank78

Discussion Starter · Aug 12, 2007

I'm loving my new Diesels from KMC, except for that the center caps rattle a little at low speeds over bumps. I want to know if this is normal or not, so I went to send an e-mail to them. Problem is that I can't find an e-mail address on their site. I don't know if i'm just blind or what. It even has a message in the "Contact" tab that says that due to a high volume of e-mails with questions to give them a couple of days to respond. That's great, but how the heck do you get a hold of them???:huh: Anyone know any secrets???

Save

1 - 7 of 7 Posts

25370

· #2 · Aug 12, 2007

When in doubt try "[email protected]"

[email protected]

Or just call Wheel Pros

"Wheel Pros is the exclusive distributor of KMC Wheels.
877.943.3577 "

Save

dank78

Discussion Starter · #3 · Aug 12, 2007

thanks, i'll give it a try tomorrow...

Save

TheBoondockTitan

· #4 · Aug 13, 2007

If you want I can call Wheel Pros for you? They have a branch local to me, litirally 5 minutes away. I call them everyday for fitments. I could just check yours while I was at it.

Save

dank78

Discussion Starter · #5 · Aug 13, 2007

TheBoondockTitan said:
If you want I can call Wheel Pros for you? They have a branch local to me, litirally 5 minutes away. I call them everyday for fitments. I could just check yours while I was at it.

That'd be awesome, and much appreciated. I've got the Diesels in 18" and i'm concerned about the center caps rattling. I know they are put in from the back of the wheel so they won't fall out, but it just doesn't sound good at low speeds going over bumps and stuff. Thanks...

Save

TheBoondockTitan

· #6 · Aug 13, 2007

I called my contact at Wheel Pros. He says what has most likely happened it that the rubber ring that was on the centercap must've dried up and broke apart. He said the cheapest way to fix it was to pull the cap off and put a rubberband in its place and it should'nt move around anymore. As long as its the push through cap.

Save

dank78

Discussion Starter · #7 · Aug 14, 2007

Thanks, i'll have to check that out.

Save

1 - 7 of 7 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month