Nissan Titan Forum banner

any rubbing issues with this setup ?

768 Views 1 Reply 2 Participants Last post by  NorCal 4x4

Before I purchase this setup
I just want to make sure that I don't have any rubbing issues with this combo. Any info would be appreciate.

I'm thinking about getting prg products on my titan..
CST spindle
-prg 2.5 spacer
-4" rear block and new u-bolts
-CST carrier bearing drop bracket
-Bilstein rear shocks
and 35x 12.5 x 18 tire with procomp 1079 wheels.( -6mm offset)
1 - 1 of 2 Posts
You should clear the spindle but will most likely need the pinch-weld-mod for fender rub. With 4.75" of backspacing you won't be quite as bad as some rims, like the MM 951 with their 4.5" b.s.

Btw, my friend has 17x9 Moto Metal 951 rims, with 4.5" b.s., and 35x12.5x17 BFG MT KM tires, and a PC stage1, 6" bracket lift, and had to do the pinch weld mod. Not too much cutting though, so with an extra 1/4" of b.s., you might clear.
1 - 1 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.