Joined
·
12 Posts
I would like to see a more detailed picture of its construction. This is based on the photos of a RC UCA that was featured in the forum recently that failed. I understand that the failure of the UCA was the ball joint, but the pictures of some of the weld joints show welds that were unaccecptable. The poor weld quality also begs the question "what was the joint design and were the parts fit up properly". Weld strength has everything to do with prep and design. It's the stingiest man who pays the most. While more expensive by a considerable sum, the PRG UCA are the way to go. Good design and quality welds throughout. My 2 cents
