Nissan Titan Forum banner

AVIC D3 Install

4851 Views 14 Replies 6 Participants Last post by  SaltyTitan
Hey guys, after reading a few posts on different installs I just completed my install of the Pioneer AVIC D3, it was relatively simple. I used the metra dash kit , which worked out pretty well. I still need to put the trim ring around the radio to complete the nice clean look.

I also installed Tview 9" headrest monitors, I wasn't to sure how the video would look, but it turned out pretty good. I did hook up the speed sensor wire which is white/red, I talked with someone from circuit city and he helped me locate it.

I know this install isnt near as detailed as some that I have read, but if you have any questions let me know and will do my best to answer them.


See less See more
1 - 1 of 15 Posts
So how do you like the Pioneer thus far? Do you have the steering wheel controls hooked up to it? I'm going to pull the trigger on one but the install kit's are the Armada typed with the extra holes that kind of throws me off. I was thinking of picking up an XE bezel but hadn't heard if that's a solution... Anyone?
1 - 1 of 15 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.