Not too sure but I don't think you'll be able to do that with the factory setup, you might have to go aftermarket as I can turn it on when I want and when I put it in reverse.
ya, aftermarket i can drive around with it on. Stalk people behind me. But stock dont think you canNot too sure but I don't think you'll be able to do that with the factory setup, you might have to go aftermarket as I can turn it on when I want and when I put it in reverse.
I like that look. Did you have to drill there? I'm interested in adding a cam to my aftermaket double din, it has a back up camera wire but how does it know when my truck is in reverse?I purchased one off of Amazon that had good reviews that mounts on the bib tailgate part. Where the handle is so it looks oem. Hooked it up to my pioneer indash I like it pretty clear image those distance lines to show you how close you are. I'll post a link to the camera I used. Good price too!
Here's a picture
Front View Camera,Chuanganzhuo Universal Normal Image Car Reverse Backup Rear/Front View Camera For All Car,Black https://www.amazon.com/dp/B00RD05MOO/ref=cm_sw_r_cp_api_s3CwybKFPC0YQ
HERE is the link to the install. This is the route i went and probably the same as him.I like that look. Did you have to drill there? I'm interested in adding a cam to my aftermaket double din, it has a back up camera wire but how does it know when my truck is in reverse?
I ran a wire from my reverse light to the reverse wire on the radio. I have a pioneer 4100nex. Run it to the power side. Mine was red with a blue tracer.I like that look. Did you have to drill there? I'm interested in adding a cam to my aftermaket double din, it has a back up camera wire but how does it know when my truck is in reverse?
Yeah I did but it's very simple. You remove the back piece on the tailgate then take the bib off so you can line it up and then drill a small hole. Cause my camera has a threaded bolt attached to it and then you use the supplied nut to tighten it through the backside. I then route the wires through the tailgate to a hole that's covered by a textured sticker and run the wires from the camera to the dash. As for the trigger wire I tapped into the reverse light as I could not find the right wire to tap into underneath the dash.I like that look. Did you have to drill there? I'm interested in adding a cam to my aftermaket double din, it has a back up camera wire but how does it know when my truck is in reverse?