[beason]

I know this is an off the wall question, but i am missing a bolt in my air filter setup, and when i installed my AEM it was the only bolt that is reused, go figure. I can just go get one from the depot, but i need the specs. size and thread pitch.

if your standing at the front of the truck, its on the edge of the box on the back right. it bolts to a tab that is right on the fender/wheel well.

 

[deerslayer]

I'll take a guess and say M6???? Just looking at it but who knows.

 

[DRTYAZN]

Look through your can of loose bolts and nuts, use any short 12mm bolt that was taken off your T, it'll work... No need to beat yourself up looking for the original one...

 

[honda250xtitan]

is it a 12mm? it seems all the bolts are either 8, 10, 12. especially on the bumper haha.

 

[bestatchess]

I'll take a guess and say M6???? Just looking at it but who knows.

I would also like to guess M6.

M6 washer hex phillips head yellow zinc bolt that fits a 10mm socket.

 

[beason]

yea i plan on just getting one from the depot. Ive been all through my stash and i dont have one that will fit. so M6 is the thread specs? and i can just eyeball the length.

Thanks guys.

 

[bestatchess]

. so M6 is the thread specs?

I am just guessing based on CAI install instructions stating that it takes a 10mm wrench. M6 means a 6 mm diameter on the threaded section of the bolt. Total guess on my part.

 

[DRTYAZN]

Apologies... I checked mine, not in use but still installed... It is a 10mm and pretty long (prob 1" in length)... Don't know why it's so long because I don't see anything being secured under it...

 

[deerslayer]

I work all day building conveyor and I'm usually pretty good on guessing sizes just by looking at it. I'm going to guess M6 unless by some weird chance it's not metric it might be 5/16.