[05dirtytitan]

Just installed a full 3'' lift in my 05. Did everything according to instructions and now my 4wd wont work and I seem to have some binding in the front end sometimes. Could someone point me in the right direction please. ALso the slip and abs light are on also. installed all new parts with the lift including wheel bearings and end links.

thanks guys

Eric

 

[ninnemannk]

What is the "full 3" lift you're referring to?


Sent from my iPhone using Tapatalk

 

[ninnemannk]

Sounds to me like you disconnected or broke the wires to a wheel sensor.


Sent from my iPhone using Tapatalk

 

[05dirtytitan]

I put 1.5" spacers in the front and put the correct upper control arms. I also did brand new wheel bearings in the front. everything is hooked up and I don't see any damage to the wheel sensors. perhaps a faulty wheel bearing? the rear I did 3" blocks and proper shocks to accommodate. I don't see any obvious sings of broken wires and everything was fine prior to the install. I also installed brand new struts with new coil springs.

 

[honda250xtitan]

i had a long response typed up but then i saw you did a 3" block in the rear. lol



post pics of the setup so we can see whats wrong.

 

[Pale Rider]

if the ABS wires were stretched at all, that would be your issue.

 

[05dirtytitan]

if the ABS wires were stretched at all, that would be your issue.

what is the solution if this was it? how could I check for this?

 

[05dirtytitan]

https://mail.google.com/mail/u/0/?u...s=1492983072853&rm=15b9cb96feb4c113&zw&atsh=1

 

[2011-pro-4x]

I'm having the same issue with the idiot lights after my R/C 6 inch suspension lift as well.

 

[honda250xtitan]

check all your abs plugs. on the spindle, and on the frame. also check the rears. if you did in fact put a 3" block in the back (which sounds stupid if you are just running a leveling kit up front) you should've bought a bracket to extend your brake lines and maybe your abs wires.