I put 1.5" spacers in the front and put the correct upper control arms. I also did brand new wheel bearings in the front. everything is hooked up and I don't see any damage to the wheel sensors. perhaps a faulty wheel bearing? the rear I did 3" blocks and proper shocks to accommodate. I don't see any obvious sings of broken wires and everything was fine prior to the install. I also installed brand new struts with new coil springs.
confused after lift install
Just installed a full 3'' lift in my 05. Did everything according to instructions and now my 4wd wont work and I seem to have some binding in the front end sometimes. Could someone point me in the right direction please. ALso the slip and abs light are on also. installed all new parts with the lift including wheel bearings and end links.
thanks guys
Eric
thanks guys
Eric
1 - 4 of 10 Posts
if the ABS wires were stretched at all, that would be your issue.
what is the solution if this was it? how could I check for this?
1 - 4 of 10 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Nissan Titan Forum
Nissan Titan Talk Forum is a community for truck owners to discuss the Titan Cummins, Warrior, Midnight Edition and more!
Full Forum Listing
