Nissan Titan Forum banner
1 - 1 of 1 Posts

· Registered
17 Posts
Discussion Starter · #1 ·
I was having some issues with engine starting. When i pulled shifter in and up it would start....after my shift linkage gave out and i replaced it i noticed some wires near the shifter were frayed and barley connected. I tried to solder it together and it seemed to be working fine but recently it’s doing the same thing. I have the column cover off so when it wont start i jiggle that connector and it starts right up.
I’ve enclosed pic of the part. Does anyone know if this is replacable or if even this is the problem?
Thanks for your guidance and help.


1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.