Nissan Titan Forum banner
1 - 2 of 2 Posts

·
Premium Member
Joined
·
1,897 Posts
It'd work fine. but by the time you buy everything it would start to add up. I bought one FT spindle for a shop and it was almost $400 for the 1 spindle. After it's all seaid and done, using all the same parts, the FT kit will be about 3/4"-1" taller than a PC kit with the same parts.
 

·
Premium Member
Joined
·
1,897 Posts
You cannot add any type of spacer to the coilovers on either Fabtech or PC kit. If you add the upper a-arms, we can machine a custom spacer to fit (it's a bit thicker for the FT kit). One gives just under an inch for the PC kit and upper arms, the other is about 1.5" of lift for the FT kit and upper arms. But any leveling kit is just way too much and the coilovers are desigend to offer the max lift possible with out the upper arms hitting the coilbucket.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top