Nissan Titan Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
6,086 Posts
Discussion Starter · #1 ·
We are all aware that the Fabtech kit comes with slightly taller spindles than the ProComp or Rancho lift kits. This allows for slightly more lift with the Fabtech kit. Why couldn't the Fabtech Spindle be used in conjunction with the PC lift? Can you buy just the spindles from Fabtech? Not that anyone would try this, just wondering if it would be possible or is it just a bad idea?
 

·
Registered
Joined
·
6,086 Posts
Discussion Starter · #4 ·
Thanks for the quick reply Greg. You answered my question.

So basically, the FT spindle CAN be combined with the PC lift to gain an extra 3/4"-1" of lift. It will cost about $800 to do so though.

Next question...

I have the PC 6" Stage 1. I can use either of the now 2 shock options that are available (RadFlo & SAW), but I cannot stack your 2" spacer ontop to gain extra lift. The Fabtech spindles, being slightlytaller, would allow for the added 2" spacer though, correct? Reason being, correct me if wrong, the shorter spindle would cause too severe of an angle in the upper ball joint/control arm?? This would prevent a proper alignment.

Thanks for the info/help.
 

·
Registered
Joined
·
6,086 Posts
Discussion Starter · #6 ·
Thanks for clearing that up Greg.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top