Nissan Titan Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
30 Posts
Discussion Starter · #1 ·
I am very excited to get it on.........one question: being a straight through 2 into one, i can look in one side and clearly see out the other...when i look through the 2 port side, about 4" in just after it becomes one straight through, there is a 'needle with a ball' sticking out about 1"...i'd swear that it looks just like one of those pins that come out of a new dress shirt collar....i called the number from where it was sent and they said it shouldn't be there...i am sure that when i figure out how to get in there with something, i should be able to pull it out, i hope.....so i guess the only challenge is to get this to match up to my pipes...the center to center inlet on the mganflow is like 4.25" and the stock looks like roughly 8"....there seems to be plenty of pipe to workwith under there, so as long as my installer has a maandrel bender, we should be ok....any comments would be appreciated
 
1 - 2 of 2 Posts
Top