Nissan Titan Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,551 Posts
I had a 2" leveling kit installed on my 4x4 2004 XE and it still ISN't LEVEL!!! It is still lower in the *** end!!! I can't stand it! Is there anything I can do now to get the front level with the back? I don't want to lower the back any, just raise the front about 1/4" to .5". I am young and have limited resources. thanks
If you can find someone with a 08 or 09 Pro 4x that is switching to aftermarket coilovers, get the stockers off them, then install your 2" spacer and you should be where ya want. IF your backend is taller than the front. You will get some UCA coil bucket contact at full droop...but it's not too bad.

It's the setup I'm running now....along with the PRG 1" rear block, shackles, t-bars.
 

·
Registered
Joined
·
1,551 Posts
Your front coils could be sagging....mine did. Heck even Todd's 08' 4x4's springs were effed up...along with the shocks...
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top