[gksmith]

I want to run wires for the M&D monitor through the passenger B-Pillar so that I can add "stuff" under the passenger seat.

How do I remove the b-pillar - or do I need to, is there enough slack to push the wires down and fish them out near the carpet?

 

[looking]

There was enough slack to push the wires through when I went through the drivers side I assume there should be plenty of room on the Pass side. There was plenty of slack in the carpet as well I didnt have to remove the carpet. Just pull back the rubber seal around door and and remove the lower floor jamb piece. Check out the write up and pics on my install.

Hope this helps.