*****JBA 3" 304 stainless turn down kit*****

nightowl · 2016-04-28

I get calls all the time from customers that would like a 3" turn down in stainless to hook up to their JBA 3" Catback exhaust systems or any 3" exhaust on the market. The item attached is 304ss with the clamp and can be installed in 20 minutes by anyone at home. This is for customers that don't want an over axle pipe and are looking for a deep loud tone or need the clearance for rock crawling or off-roading. Part number is below and prices start at $40.00 shipped for the complete kit. DEC300ATD.

GalaxyPro4X11

· #2 · Apr 28, 2016

I will probably try this out at some point.

Reply

Save

Like

Reactions: 2

TheHops

· #3 · Apr 29, 2016

I've actually been looking for a 304ss turndown. I've been considering changing up my setup and this may fit the bill. I'll have to take some measurements and see if it'll work. Do you happen to know the overall length of this tip?

:nerd: 2010 Pro-4x CC [Snoopy] :nerd:
Suspension: 6 inch ProComp, ATX AX181 teflons, 305/70R18 Cooper STT Pros, ICONs on all corners, DK UCAs, DK tie rod ends, sway bar delete.
Power: UpRev, Airaid MXP CAI, JBA LTs, Cajun resonated bpipes, SummitRacing y-pipe, Borla 40085, UQ res.
Body: Leer 100RCC (reinforced), RKSport ram-air hood, FabFours premium front bumper, Rigid grille, Bushwacker smooth flares, Go Rhino Dominator D2 steps, spray in bed liner.
Roof: Thule tracks, frontrunner roof racks. Front: 40" bar, L/R facing 10" light bars, MAXTRAX mounts, 20gal spare fuel brackets. Rear: axe/shovel, CVT RTT, 10" rearward light bar
Lighting: Full internal/external LED swap. Front: 40"/20" Amber/White LED bars, two 3" A/W pods. Sides/Rear: Three 10" white bars.
Misc: Mile Marker SEC9.5 (ES), Cobra 75WXST, 600W PSW Inverter, ARB CKMTA12, WeatherTech floor liners, DU-HA rear underseat tub, AVS in-channel visors, stubby antenna, seat mounted fire extinguisher, cajun axle vent.
Pending Install: Fab fours premium rear bumper, CJD trac bars, C-30s, DK variable height shackles.

Reply

Save

Like

LaxDfns15

· #4 · Apr 29, 2016

Can we get a video of this one too?:big_grin:

What's the sound like compared to JBA catback with no UQ?

Reply

Save

Like

T

Titan 05

· #5 · Apr 29, 2016

TheHops said:
I've actually been looking for a 304ss turndown. I've been considering changing up my setup and this may fit the bill. I'll have to take some measurements and see if it'll work. Do you happen to know the overall length of this tip?

7" is the overall length of the turndown.:smile:

Reply

Save

Like

Reactions: 2

nightowl

Discussion Starter · #6 · Apr 30, 2016

LaxDfns15 said:
Can we get a video of this one too?:big_grin:

What's the sound like compared to JBA catback with no UQ?

A lot deeper and louder with some drone I'm sure. This is what is great as it can be easily removed and replaced as the mood changes...lol

Reply

Save

Like

Reactions: 1

TheHops

· #7 · Apr 30, 2016

nightowl said:
A lot deeper and louder with some drone I'm sure. This is what is great as it can be easily removed and replaced as the mood changes...lol

I'm debating on switching my current setup with a better y-pipe, an xr-1 and this tip. No UQ. I like to live dangerously. :eyebrow:

:nerd: 2010 Pro-4x CC [Snoopy] :nerd:
Suspension: 6 inch ProComp, ATX AX181 teflons, 305/70R18 Cooper STT Pros, ICONs on all corners, DK UCAs, DK tie rod ends, sway bar delete.
Power: UpRev, Airaid MXP CAI, JBA LTs, Cajun resonated bpipes, SummitRacing y-pipe, Borla 40085, UQ res.
Body: Leer 100RCC (reinforced), RKSport ram-air hood, FabFours premium front bumper, Rigid grille, Bushwacker smooth flares, Go Rhino Dominator D2 steps, spray in bed liner.
Roof: Thule tracks, frontrunner roof racks. Front: 40" bar, L/R facing 10" light bars, MAXTRAX mounts, 20gal spare fuel brackets. Rear: axe/shovel, CVT RTT, 10" rearward light bar
Lighting: Full internal/external LED swap. Front: 40"/20" Amber/White LED bars, two 3" A/W pods. Sides/Rear: Three 10" white bars.
Misc: Mile Marker SEC9.5 (ES), Cobra 75WXST, 600W PSW Inverter, ARB CKMTA12, WeatherTech floor liners, DU-HA rear underseat tub, AVS in-channel visors, stubby antenna, seat mounted fire extinguisher, cajun axle vent.
Pending Install: Fab fours premium rear bumper, CJD trac bars, C-30s, DK variable height shackles.

Reply

Save

Like

LaxDfns15

· #8 · Apr 30, 2016

Hmm. Might get this and keep my tailpipe to get the UQ on it for when I travel with people. Everyone else hates the noise but I can't bring myself to get the UQ just yet.

Reply

Save

Like

nightowl

Discussion Starter · #9 · May 1, 2016

Exactly what I would do

Reply

Save

Like

JBA 3" 304 stainless turn down kit

nightowl

Attachments

GalaxyPro4X11

TheHops

LaxDfns15

Titan 05

nightowl

TheHops

LaxDfns15

nightowl

Top Contributors this Month