Nissan Titan Forum banner

kenwood 7100 hardware/wiring needed

2777 Views 8 Replies 6 Participants Last post by  EXILE
I am going to purchase a new dnx7100 in the next few days. I am wondering from those of you who already have this unit, what accessories will I need to make it 100% ready to hook up? Any wiring harnesses, ipod connectors, gps antennas ect..... I am getting the backup camera already, just not sure what else i need to make the unit work.

Also where can i get a new faceplate that has the proper hole for the hazard button?

Also I already have sirius satelite hooked up with the unit mounted outside the console, but wiring behind radio (done by best buy). Will this work this way with the 7100?

The only additionals i am hooking up are the ipod and backup camera (ccd2000)

Thanks in advance for the help,

1 - 1 of 9 Posts
I would go with the factory XE bezel instead of a dash kit unless you have an 08 or dual climate controls.
1 - 1 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.