Nissan Titan Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
27 Posts
Discussion Starter · #1 ·
I need a diagram or description of the where the heater core is and where the valve is located that does the mixing for cold/hot air. My heat stopped working today and I suspect it is the valve. Check most everything else. I got automatic, dual climate control. Any help would be greatly appreciated cause its currently -15F out here.
 

·
Registered
Joined
·
27 Posts
Discussion Starter · #5 ·
Thanks for the help guys. It was the water flow valve. Must of been frozen or something. I took a blow dryer and put it under it for about 15 mins. Started the truck and it began letting the warm coolant through. Maybe too much water content in the coolant? I'm probably gonna flush the system once it gets a bit warmer. Thanks again.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top