Nissan Titan Forum banner

1 - 17 of 17 Posts

·
Registered
Joined
·
6,373 Posts
Anyone change the layout of their camping trailer or have any mods you are proud of?
I wish I could customize the floorplans of several trailers...
 

·
Registered
Joined
·
12,510 Posts
I have never done it but I am sure it wouldnt be that hard to do. What do you have in mind?
 

·
Registered
Joined
·
515 Posts
Discussion Starter #4
i dunno ..just like towel racks...bunk steps...or raising a bunk a little higher etc. ...i have a great layout avail..but i'm not too keen that one of the bunks is floor level.
 

·
Premium Member
Joined
·
141,094 Posts
The removable giant cutting board I installed on the side of my old trailer was invaluable.
 

·
Registered
Joined
·
1,146 Posts
Only thing I've done is install an Ultra Fab electric jack, got tried of cranking it hitching and unhitching. Next on the list is mounting an LCD inside then putting a matching cabinet door where the TV is now. I like the layout so no need to change.
 

·
Registered
Joined
·
515 Posts
Discussion Starter #7
yep yep ..already got plans to close in the tv shelf and mount an lcd..any probs with drilling into the outer walls or are they pretty thick? I mean it's not like it has "studs" per say...
 

·
Registered
Joined
·
484 Posts
Actually I was wondering about this as well. I don't feel comfortable just drilling into the side, seems to easy to cause a leak.
 

·
Registered
Joined
·
1,146 Posts
Mines going on the wall between the bunks and dinette area. I've seen a few that did this and they put a small plywood brace on both sides of the wall and drilled and use a lag bolt to fasten them. Attached the LCD mount to the base and your done.
 

·
Registered
Joined
·
484 Posts
Actually if I was replacing the built in CRT this is what I will do, I am more speaking about the bedroom area.
 

·
Registered
Joined
·
690 Posts
I once saw a trailer with mud terrain tires on it. :huh:

I still cant figure that one out.
 

·
Registered
Joined
·
515 Posts
Discussion Starter #12
LOL!

my aunt a while back was doing "somehting" whatever i'm not sure..but managed to cut a hole in the side of her trailer..i'm a little nervous about screwing anything into the walls etc....if anyone has done something really cleaver with their unit drop me a pic and note! :cheers:
 

·
Registered
Joined
·
6,373 Posts
I once saw a trailer with mud terrain tires on it.
You made me laugh! Actually my Jayco Baja 10Z tent trailer HAS Dunlop mud radials on it!
It's also got nice alloy wheels too...
 

·
Registered
Joined
·
16 Posts
Best thing I did to mine was replace the "Camper Queen" mattress with a good quality regular queen. Camper queens are the same width as a regular queen, but 6 inches shorter.

I replaced it with a much better mattress so it is much softer to sleep on and my feet don't hang off the end of the bed.

I had to replace the base with a little longer piece of plywood to support the longer mattress. No big deal.
 

·
Registered
Joined
·
484 Posts
Got any info on what kind of mattress you got? That is our only complaint with our TT so far.
 

·
Registered
Joined
·
1,294 Posts
We went to Verlo mattres factory and had them make us one. Nice firm mattress to fit. 425.00.:dunno: Camping world also sells them too, but they had none in the store to try.
 

·
Registered
Joined
·
16 Posts
bighitter said:
Got any info on what kind of mattress you got? That is our only complaint with our TT so far.
Just went with a standard Queen size Serta. Be careful not to go too firm since it won't be sitting on a box spring. My wife and I chose our mattress by pulling the mattresses off the beds in the store and laying on them on the floor to simulate not having a box spring.
 
1 - 17 of 17 Posts
Top