Joined
·
17,244 Posts
It just pulls out.
Need help asap!! Manifold install. Can't get the dipstick out
How the he'll does the dipstick come out. I removed the single bracket that holds it in. I have the manifold completely unbolted. It can't get it out. Should it just pull out,unscrew, or am I missing some obvious thing? Can't believe I am getting hung up on the dam dipstick.
Need help asap. In the middle of the install
Need help asap. In the middle of the install
1 - 6 of 6 Posts
if u got it then it dont matter but future reference this stuff called throttle body cleaner or intake cleaner (a spray) is good wat it does it freezes stuff so when u freeze things stuff shrinks
wat u were hung up on was the o-ring on the end of the dipstick tube i was hung up as well when i did my manifold. Spray this stuff at the o-ring or into the area around the
hole were the tube would go into and should shrink the 0-ring for thats how u get it out
also for furture reference this stuff works for all typss of rubber o0rings that may cause u trouble not stying in place or not fitting properly spray this and it should work
fyi its easyiest to lift motor up to do manifolds
-nissan tec
wat u were hung up on was the o-ring on the end of the dipstick tube i was hung up as well when i did my manifold. Spray this stuff at the o-ring or into the area around the
hole were the tube would go into and should shrink the 0-ring for thats how u get it out
also for furture reference this stuff works for all typss of rubber o0rings that may cause u trouble not stying in place or not fitting properly spray this and it should work
fyi its easyiest to lift motor up to do manifolds
-nissan tec
1 - 6 of 6 Posts
