Nissan Titan Forum banner
1 - 1 of 1 Posts

· Registered
3 Posts
Discussion Starter · #1 ·
Hi all, new member here hoping for some help with my SS brake line installation.

Last week I replaced my front rotors and calipers with the Stillen Big Brake kit and put new rotors and pads on the rear. While swapping everything out i went ahead and upgraded the brake lines. I was able to change 4 of the 6 lines. The two inner rear lines proved to be a challenge as I didn't have the proper wrench size for the nut in the center of the truck just under the bed. Does anyone know the nut size so I can go out and purchase the proper brake line wrench size?

Thanks for the help.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.