Nissan Titan Forum banner

No audio from door speakers only subs

5145 Views 34 Replies 7 Participants Last post by  mbquart1
Just yesterday I went to the store when I got back in the truck I had no audio. the head unit is on and works fine and the subs work as the bass of whatever is playing in the radio is hitting. But no audio from the door speakers. The truck came with an in dash milion brand and I think boss aftermarket door speakers and tweeters on the dash. when I came home with it I already knew it was a piece of crap. It's slow and bad graphics the cd/dvd doesn't work nor the iPod connection no gps only radio stations Bluetooth and sd card, even the rear camera has to be turned on manually through the head unit lol takes forever to read the sd card but it did its job so I was just going to wait till it crapped out which I think it did because of the problem I'm having. Took it to a stereo shop and they said it was the head unit because my subs are still playing, but My subs are hooked up to the head unit via rca's and remote wire so im not sure Im not big on radio electronics more mechanical stuff so not sure how to tackle this one. I've already taken the stereo out and checked for any ripped cut wires or loose connections and everything is good. And it isn't a hack job they used a harness from what I can see.
1 - 7 of 35 Posts
I don't know anything about the HU you have, but if you have a short on a speaker wire the radio could be going into protect and shutting down the internal amp which would cause everything but the subs to quit. You would think it would display something when it does tho.. But if it's cheap it may not.
Is it overheating??
I think it an intermittent short on a speaker wire or bad HU
The Kenwood will be fine.
Asking what head unit to get on here is like asking what's the best food. Everyone has a preference. As
Long as you stick with a major brand (Kenwood, Alpine, Pioneer, Clarion) you should be fine. Try to stay away from Power Acustik, Boss, Dual. Or and cheap brand. Remember you get what you pay for in most cases.
It's depends on the 6x9. You have to
Look at the nominal power rating on it
Use the factory bezel and bracket..it will match then and fit properly. I only had to use a kit on one that had an OEM non 6disc
I don't know what going on with yours. But the only time I have needed the kit is when I was changing one this a 6disc changer. If the bezel has had a double din hole I just use the Oem bezel and brackets and it fits perfectly.
1 - 7 of 35 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top