Joined
·
422 Posts
Well i saw another thread about an intake manifold that someone wanted to make out of sheet metal but abandoned the project but I used to be into drifting (see my avatar) and chris forsberg runs an orange 350z with a vk56 swap and this thing is sick, when i saw it at formula d up close i noticed the intake manifold was a custom made unit made of sheet metal. too bad we couldnt get some kind of spec's from the manifold on this setup because this car is sick, and because of the clearence issues in the car the throttle body faces the driver at the back of the engine but they wouldnt be using it if it didnt work, when the car first came out it had the stock manifold but now they have this custom unit. here are a couple pics and a link to the rest of the pictures, i hope this give some of you guys some hope that this has been done and it does work!:cheers:
http://www.chrisforsberg.com/v/rebuild/titanz/
http://www.chrisforsberg.com/v/rebuild/titanz/
Attachments
-
6.2 KB Views: 951
-
6.4 KB Views: 2,438
-
6 KB Views: 440
-
6.7 KB Views: 834
-
6.1 KB Views: 821