Nissan Titan Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2,408 Posts
Did the moldings not come with double sided tape? The service manual states that is how the factory ones are held on so that would be the best option to install yours. Make sure to clean the area with isopropyl alcohol to degrease the area.

FROM THE SERVICE MANUAL:

INSTALLATION
 On vehicles coated with Hard Clear Coat, use double-faced 3M adhesive tape Product No. 4210 or equivalent,
after priming with 3M primer Product No. N200, C-100 or equivalent.
 The repair parts are also affixed with double-faced adhesive tape.
 To re-use existing molding, clean all traces of double sided tape from the molding and apply new doublefaced
tape to the molding.
1. Clean the panel surface with isopropyl alcohol or equivalent to degrease the surface.
2. Heat the panel and molding tape surface to 30° to 40°C (86° to 104°F).
3. Remove the backing sheet from the tape surface.
 Align the locating pin into the hole in the outer door.
 Continue aligning the pins into their corresponding holes in the outer door during installation.
4. Press ends by hand and use a roller to apply 5 kg-f (11 lbs-f) to press molding to door surface.
 Apply even pressure along molding to insure proper wet out.
CAUTION:
To secure contact, do not wash vehicle for 24 hours after installation.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top