Nissan Titan Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
140 Posts
Discussion Starter · #1 ·
So i purchased all of the body side moldings for my nissan titan from courtesyparts.com and i already knew that drilling holes in my door would be a task. I actually took my titan to a body shop and they said that they would not do the job becuause they would have to drill the holes in the doors, they then suggested that i used double sided tape, the only problem i have with that is that i do not think that it would look right or they would fall off. On the front side moldings, there are plugs that would fit into drilled holes and im sure that they would stay so i am debating drilling the holes myself; now on the back side moldings, there are no plugs and drilling holes would do no good so i may have to use the tape for that...anyone have any suggestions?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top