i recently installed a front leveling kit on a new 08 4wd titan. i cannot get either spindle to stay tight with upper control arm. used torque first. then went to air wrench. then both air wrench and the tap method trying to get it to cinch up. but no luck. seems tight for about 30-40 miles then gets loose and sloppy again. any suggestions.
jack
Also did you get it to seat fully again before you started tightening the nut? Never re-use a cotter pin. Is this on a PRG kit? if so a quick call to Greg should overload you with help.
i believe that is my problem. i cant get it to seat properly. ive got the nut as tight as possible but when i back it down ball joint begins to slide out of spindle.